2021-10-22 18:16:49 Find the results of "

sxmbadm in sap pi

" for you

SXMB_ADM in PI and ECC | SAP Community

Hi Guys, Im trying to get through the readiness checks in XI before I start the development Im confused on what I should enter in SXMB_ADM in PI and ECC SXMB_ADM -> IntegrationEngineConfiguration R

Integration Engine Configuration (SXMB_ADM) – SAP Lessons Learned

Integration Engine Configuration (SXMB_ADM) When working with SAP PI/PO you usually use it in scenarios involving ECC integration with 3rd party systems. Therefore, maintaining connection between ECC and SAP PI/PO is essential step in every project.

SAP PI Administration: How to configure and monitor the ...

We can configure and monitor the Integration Engine using a transaction SXMB_ADM (Integration Engine – Administration). We should configure the Integration Engine for the existing Landscape before we can use it. We can check the global configuration settings consistency by F7 or by clicking on check button. Following screen should appear with ...

Parameters for Archiving - SAP

SXMB_ADM -> “Define Interfaces for Archiving and Retention Periods” -> “Retention Periods” button. SXMB_ADM -> “Integration Engine Configuration” -> choose 'ARCHIVE' category and then press the “Configuration” button. In both places you can set the PERSIST_DURATION parameter for both ASYNC and SYNC messages.

Mapping Trace in SAP PI 7.31 Single Stack | SAP Blogs

You have developed your Java or XSLT mapping code in SAP PI 7.3x Java only, or you have migrated your Java or XSLT mapping to one. And you are wondering where all the Trace information thrown during run-time

Proxy for Multiple ESRs | SAP Blogs

The problem over here is that at one time, the SPROXY of a SAP system can be connected to only one ESR. But, we need to trigger particular proxy message of a SAP system to a particular PI system and other proxy messages of the same SAP system to another PI system in another landscape. Solutions. This requirement can be attained in two ways.

Integration Engine Configuration - SAP

o Go to SXMB_ADM transaction. Choose Integration Engine Configuration. o In the Category field, choose the parameter category. o Choose Change Specific Configuration Data. o Go to change mode, this allows to define the new values to the parameters or change the existing values of the parameters.

Automation of SAP PI/PO monitoring report using HTTP channel ...

Automation of SAP PI/PO monitoring report using HTTP channel September 20, 2019 September 20, 2019 webadmin I have seen few blogs for automating monitoring report but could not complete my scenario since my system is on 7.3 dual stack and REST channel could not be installed with the available SP level.